Composite poolside deck with built-in steps in Folsom, CA
Custom Deck & Patios

Deck Replacement Cost in 2026: What You'll Really Pay

Most homeowners pay between $4,000 and $19,000 to replace a deck, with an average around $11,000, according to Forbes Home. That figure covers building the new deck, tearing out the old one and reassessing the site for the new design. Where you land in that range depends on size, material, structure and what is hiding under your old boards.

This guide breaks the number into parts you can check against a quote: price per square foot, worked examples for common deck sizes, the extras that surprise people, and how to decide between repairing and replacing.

Key Takeaways

  • A typical deck replacement costs $4,000 to $19,000, averaging about $11,000, and most decks measure 150 to 400 square feet.
  • A professionally built deck usually costs $30 to $60 per square foot, and labor alone is about $15 to $35 of that.
  • Demolition and junk removal can add $5 to $14 per square foot on top of the new build.
  • A 14x20 deck is likely $11,200 to $16,800, and a 20x20 deck $16,000 to $24,000.
  • If the framing is sound, repairs average roughly $2,000, so a good inspection comes before any replacement decision.

How much does it cost to replace a deck?

The national picture is a wide band. Forbes Home puts the typical range at $4,000 to $19,000, averaging $11,000, and notes that most decks fall between 150 and 400 square feet. A smaller wood deck can come in near $10,000, while an average professionally built new deck lands around $20,000 to $25,000, and maintenance-free materials such as composite or PVC can reach $60,000 or more, according to a deck builder quoted by Better Homes & Gardens.

Why such a spread? Three things drive it:

  1. Size. More square footage means more material and more labor hours.
  2. Material. Pressure-treated lumber, composite, PVC and hardwoods sit at very different price points.
  3. Scope. A flat, ground-level deck is a different job from an elevated deck with stairs, railings and a structural inspection.

A fourth factor sits outside your control: your local labor market. Remodeling labor in California metro areas generally costs more than the national figures suggest, so treat the national numbers as a starting point and ask for a written local estimate.

Deck replacement cost per square foot

NerdWallet reports that a professionally built deck typically costs $30 to $60 per square foot, citing Angi, and that size is one of the biggest price factors. The same page says material is only about half the total, and that homeowners can expect to spend $15 to $35 per square foot on professional labor.

That split is useful when you read a quote. If a contractor’s price per square foot is $45, roughly $15 to $35 of it should be labor and the rest materials, hardware and overhead. A quote that is mostly labor or mostly materials deserves a question about what is included.

Here is how that range plays out on a few sizes. These are simple multiplications of the $30 to $60 range, meant for budgeting, not as quotes.

Deck sizeSquare feetAt $30 per sq ftAt $60 per sq ft
10x12120$3,600$7,200
12x16192$5,760$11,520
14x20280$8,400$16,800
20x20400$12,000$24,000

Note that NerdWallet’s own estimates for the two largest sizes start higher than the simple low end: it says a 14x20 deck is likely to cost $11,200 to $16,800, and a 20x20 deck $16,000 to $24,000. Those work out to about $40 to $60 per square foot, which is a more realistic floor once you account for hardware, stairs and a professional crew.

What a 14x20 or 20x20 deck costs

Two sizes come up constantly because they fit a lot of backyards.

A 14x20 deck (280 square feet) is likely to cost between $11,200 and $16,800, according to NerdWallet. That is a comfortable space for a dining table, a grill and a few chairs.

A 20x20 deck (400 square feet) is likely to cost between $16,000 and $24,000, per the same source. This is at the top of the typical size range Forbes describes, so it sits toward the upper half of the national price band.

Both figures assume a standard build. Elevated decks, multiple levels, curved edges, built-in seating and premium railings push you above them.

Costs people forget to budget

The price per square foot is for building. Replacement adds work that a brand-new deck on bare ground does not need.

Demolition and disposal

Forbes Home says you may need to add $5 to $14 per square foot to demolish the old deck and haul away the debris. On a 300-square-foot deck, that is $1,500 to $4,200 before a single new board goes down. Ask whether the quote lists demolition as its own line.

Permits and inspection

Many jurisdictions require a permit to replace a deck, especially one attached to the house or raised off the ground. Permit fees are commonly quoted in the low hundreds of dollars, but rules differ by city and county. Your contractor or your local building department can tell you what applies to your address. Elevated or complex decks may also need a structural inspection or engineering review.

Framing and structural repairs

This is the biggest wildcard. Homeowners often assume only the surface boards are worn, then find rotted joists, a failing ledger board where the deck meets the house, or footings that have shifted. Replacing framing adds both lumber and labor, and it is much cheaper to find out before the contract is signed than halfway through demolition.

Railings, stairs and lighting

These are frequently priced separately. Railings are typically priced per linear foot and stairs per step or run. Built-in lighting is another add-on. When you compare two quotes, check that both include the same railings, the same number of steps and the same lighting, or the cheaper one may simply be the smaller scope.

A checklist for reading a quote

  • Is demolition and disposal listed, with a price?
  • Are permits included, and who pulls them?
  • Is the framing being replaced, reused or inspected first?
  • What material is specified, by brand and grade?
  • Are railings, stairs and lighting included?
  • How are surprises handled, for example rot found after demolition?

How material changes the price

Material is where you have the most control over cost, and it also decides your maintenance for the next 15 to 25 years.

  • Pressure-treated wood is the budget choice and the usual way to get a smaller deck near $10,000. It needs regular cleaning and sealing to last.
  • Composite costs more up front and asks for far less upkeep, with no sanding, staining or sealing cycle.
  • PVC sits at the premium end and, with composite, accounts for the $60,000-plus projects mentioned by the builder quoted at Better Homes & Gardens.
  • Exotic hardwoods such as ipe are the most expensive way to get a natural wood look.

If you plan to stay in your home a long time, compare the cost over 15 years, not just the day-one price. A cheaper deck that you reseal every couple of years costs you weekends and materials as well as money. If you are leaning toward low maintenance, our page on composite decks shows what that option looks like, and our wood decks page covers the classic route.

Repair or replace: how to decide

Repairs are the cheaper path when the structure is sound. Bob Vila puts the average deck repair at $2,019, with a typical range of $859 to $3,321. Compare that with the $4,000 to $19,000 replacement range and the logic is clear: if a few boards, a loose railing or a section of fascia is the problem, repair first.

Replacement starts to make sense when:

  • The joists, beams or ledger board are soft, rotted or visibly sagging.
  • The footings have shifted or heaved, so the surface will not stay level.
  • Repairs are happening every year and the cumulative bill is climbing.
  • The deck was built long ago and no longer meets current safety expectations for railings or stair spacing.
  • You want a different size, shape or material than the deck you have.

A simple test: poke the framing underneath with a screwdriver. If it sinks in easily, the problem is deeper than the boards. A contractor should also check the connection to the house, since a failing ledger is a safety issue and not a cosmetic one. Do not step onto a deck you suspect is unsafe, and have a licensed contractor or your local building department assess it.

Ways to keep the budget in check

There is no trick that makes a good deck cheap, but there are choices that stretch a budget without cutting corners.

  1. Reuse sound framing. If the substructure passes inspection, replacing only the surface and railings saves the largest line items.
  2. Right-size the deck. Every square foot costs $30 to $60. Trimming a 20x20 plan to 16x20 saves 80 square feet, roughly $2,400 to $4,800 at that rate.
  3. Simplify the shape. Fewer corners, levels and angles mean fewer cuts and less labor.
  4. Phase the extras. Lighting and built-in seating can often be added later, as long as the structure is planned for them.
  5. Get itemized quotes. Line items for demolition, framing, surface, railings and stairs let you compare scope honestly.
  6. Book off-peak. Contractors are often busiest in spring and early summer, so ask what scheduling flexibility does for the schedule and the price.

Is $10,000 enough for a deck?

Sometimes. A smaller pressure-treated wood deck can come in around $10,000, as the builder quoted by Better Homes & Gardens notes. At $30 to $40 per square foot that is roughly 250 to 330 square feet of finished deck, but only if the framing is in good shape and you are not adding much beyond the surface. Demolition, permits, railings and stairs eat into that budget quickly, so a $10,000 plan usually means a simple, modest deck.

Our perspective on replacing a deck

A deck replacement goes wrong when the price on paper is only part of the real price. The homeowners who are happiest at the end are the ones who knew, before signing, what was being demolished, what was being reused and what would happen if the crew found rot.

That is why we build our approach around up-front pricing and quotes with no surprises. We pair architect-led planning with full project management, so the design, materials and schedule are settled before work begins and one team is accountable from the first consultation to the last screw.

We also think durable materials are worth discussing early. Choosing a surface and framing that suit your yard, your budget and how much upkeep you want to take on usually matters more than shaving a few dollars per square foot at the start. With more than a decade of experience and over 200 completed projects, we have learned that clear communication about scope is what keeps a project calm.

Plan your deck project with Central Builders

If you are in the Sacramento area and want a written, itemized estimate, we handle custom decks and patios with design, project management and material procurement under one roof. Our decks and patios page shows what we build.

For shade and cover over the space you are planning, our published starting prices are $6,500 for aluminum patio covers and $18,500 for wooden patio covers. You can see how we have combined a cover with a deck in our Folsom poolside project and our timber-composite patio cover. If you are updating other exterior parts of the house at the same time, we also do siding and window and door replacement. Start a conversation through centralbuilderinc.com.

Frequently asked questions

How much does it cost to replace a 20x20 deck?

NerdWallet says a 20x20 deck is likely to cost between $16,000 and $24,000. That assumes a standard professional build. Elevated decks, premium materials, extra railings and structural repairs raise it.

How much would a 14x20 deck cost?

A 14x20 deck is likely to cost between $11,200 and $16,800, according to NerdWallet. Demolition of an old deck, permits and stairs are the extras most likely to move your total within or above that band.

Can you build a deck for $10,000?

Yes, if it is a smaller pressure-treated wood deck with simple features and sound existing framing. Larger decks, composite or PVC surfaces, and add-ons such as railings, lighting and stairs push the price past $10,000 quickly.

Is it cheaper to repair or replace a deck?

Repair is cheaper when the structure is solid. Repairs average about $2,019, while replacement typically costs $4,000 to $19,000. If joists, beams or the ledger board are rotted or the footings have moved, replacement is the safer investment.

Does the deck replacement cost include tearing out the old deck?

Not always, so ask. Demolition and junk removal can add $5 to $14 per square foot. A clear quote lists it as its own line next to the build cost.

Talk with our team

Every home is different, so we confirm scope, pricing and any permit requirements for your project during a free in-home consultation. Call Central Builders Inc. at (916) 347-7373 or request your free estimate.

Categories

Start Your Project

First name
Last name
Phone number
Email Address
Tell us about your project
Thank you! Your submission has been received!
Oops! Something went wrong while submitting the form.
*By submitting this form, you consent to receive calls and texts from us about your project. Msg/data rates may apply. Reply STOP to opt out.
Get a Free Remodeling Estimate in Sacramento
Thinking about remodeling your home? Get a free, no-obligation estimate from our Sacramento team.
Discover your options
Get expert recommendations
See what your project will cost
Why Sacramento Homeowners Choose Central Builders?
At Central Builders Sacramento, we specialize in:
1. Kitchen remodeling
2. Bathroom renovations
3. Full home upgrades
“ We don’t just build — we guide you through the entire process”